Put it in the shop today, trying to figure out why it starts and then quits.

 

Put on my new Superwinch LP10000, installed a rear reciever hitch, finally pulled my dead 4.0l engine out....has a new clutch...Sweeet!, only good thing attached to the motor...
now looking for a cheap used one to toss in....Ya I know I can't use the winch til I have a motor...

 

Changed the O2 sensor....Bank 1 Sensor 2. A real bugger to get the old one out...a snap to put the new one in...Works like a charm

 

Didn't really do it today. But last week I helped my budding install a crossover steering setup in my jeep and rebuilt my clutch. Have to go back to his shop on wednesday to do the last couple of things for the steering.

 

Just put on some new stainless handles. Took 2 hours, looks Real Puuurdy!!

 

Put in my cheap junkyard motor in today....had to clean out a bunch of sludge out from under the valvecover and dropped the pan to clean out the oil pickup....
Sounds ok....time will tell....

 

The drivers side outside door handle broke back in Dec. have been opening the door from the other side all winter, or leaving the window down.
Today it was kinda warm and I didn't have much else to do so fixed it.........

 

Oil Change............

 

Top Off And Sun In.........

 

Finally Got my BDS lift with the ADJ front track bar!!! Now i have to find the time to put it in :( Still waiting on my in dash winch controller also... lol