Re: Advice needed - recurring rear axle oil seal leak
That would be unlikely seeing as they ran out of the 20's for the last
of the CJ7's and used the Dana 44. I can't see them reinventing something for the end of a production line. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Canadian Off Road Trips Photos: Non members can still view! Jan/06 http://www.imagestation.com/album/pi...?id=2115147590 (More Off Road album links at bottom of the view page) "L.W.(Bill) ------ III" wrote: > > OK, Thanks for the report on your 1986 CJ-5. They must have change > it to the AMC 20 design, I previously thought only Chrysler/Daimler > would f**k up a Dana. > God Bless America, Bill O|||||||O > mailto:-------------------- http://www.----------.com/ > > Deano wrote: > > > > Just an update on this thread. Despite Bill's diagram, the D44 on the > > 86 CJ7 in fact has only 1 seal per side and it is outboard from the > > bearing. There is no grease seal, so the bearing is lubricated by the > > axle oil. This was confirmed when mine was taken apart again in the > > process of confirming that the rear-end is not salvageable due to a > > spun bearing (compliments of the PO) - appears as though the housing > > has been stretched/warped by the heat and will no longer hold a seal. |
Re: Advice needed - recurring rear axle oil seal leak
That would be unlikely seeing as they ran out of the 20's for the last
of the CJ7's and used the Dana 44. I can't see them reinventing something for the end of a production line. Mike 86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00 88 Cherokee 235 BFG AT's Canadian Off Road Trips Photos: Non members can still view! Jan/06 http://www.imagestation.com/album/pi...?id=2115147590 (More Off Road album links at bottom of the view page) "L.W.(Bill) ------ III" wrote: > > OK, Thanks for the report on your 1986 CJ-5. They must have change > it to the AMC 20 design, I previously thought only Chrysler/Daimler > would f**k up a Dana. > God Bless America, Bill O|||||||O > mailto:-------------------- http://www.----------.com/ > > Deano wrote: > > > > Just an update on this thread. Despite Bill's diagram, the D44 on the > > 86 CJ7 in fact has only 1 seal per side and it is outboard from the > > bearing. There is no grease seal, so the bearing is lubricated by the > > axle oil. This was confirmed when mine was taken apart again in the > > process of confirming that the rear-end is not salvageable due to a > > spun bearing (compliments of the PO) - appears as though the housing > > has been stretched/warped by the heat and will no longer hold a seal. |
All times are GMT -4. The time now is 02:31 PM. |
© 2024 MH Sub I, LLC dba Internet Brands