4 inch suspension nitpicking
#61
Guest
Posts: n/a
Re: 4 inch suspension nitpicking
You can remove the rear shaft, put it into 4x4 and drive it or remove
the front shaft and drive it on 2 wheel drive.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> Wait, instead of removing my front driveshaft couldn't I jack up the rear
> end, support it with jackstands and remove the wheels putting the lugs back
> on to keep the drums on and put it in gear to find vibes that way? Or
> should I just take off the front and street drive it?
>
> Troy
the front shaft and drive it on 2 wheel drive.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> Wait, instead of removing my front driveshaft couldn't I jack up the rear
> end, support it with jackstands and remove the wheels putting the lugs back
> on to keep the drums on and put it in gear to find vibes that way? Or
> should I just take off the front and street drive it?
>
> Troy
#62
Guest
Posts: n/a
Re: 4 inch suspension nitpicking
The top end of the track bar might have moved too. Did you get a new
rim also?
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> I was on a one way two lane road, making a left turn from the right lane.
> The left lane car should have been making a left turn also but he went
> straight and hit me square in the side as I was turning left. His car was a
> little pos and went under my jeep. Luckily he hit my step bars under the
> door, cuz I didn't get any body damage, but it pushed me sideways (from the
> left) into the curb on my right where I came to a dead stop. The right side
> of the rear end hit the curb and stopped me, bending the rear end up so I
> got a factory new one under there. Possibly the bracket being pushed so
> hard by the weight of 2 vehicles got a tad bent over? Or maybe the track
> bar folded a bit? I don't know. I'm gonna look around for that stuff again
> today.
>
> I'm about to go remove the front driveshaft and see if the vibes are from
> that or not. I'll let ya'll know what happens!
>
> Troy
rim also?
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> I was on a one way two lane road, making a left turn from the right lane.
> The left lane car should have been making a left turn also but he went
> straight and hit me square in the side as I was turning left. His car was a
> little pos and went under my jeep. Luckily he hit my step bars under the
> door, cuz I didn't get any body damage, but it pushed me sideways (from the
> left) into the curb on my right where I came to a dead stop. The right side
> of the rear end hit the curb and stopped me, bending the rear end up so I
> got a factory new one under there. Possibly the bracket being pushed so
> hard by the weight of 2 vehicles got a tad bent over? Or maybe the track
> bar folded a bit? I don't know. I'm gonna look around for that stuff again
> today.
>
> I'm about to go remove the front driveshaft and see if the vibes are from
> that or not. I'll let ya'll know what happens!
>
> Troy
#63
Guest
Posts: n/a
Re: 4 inch suspension nitpicking
The top end of the track bar might have moved too. Did you get a new
rim also?
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> I was on a one way two lane road, making a left turn from the right lane.
> The left lane car should have been making a left turn also but he went
> straight and hit me square in the side as I was turning left. His car was a
> little pos and went under my jeep. Luckily he hit my step bars under the
> door, cuz I didn't get any body damage, but it pushed me sideways (from the
> left) into the curb on my right where I came to a dead stop. The right side
> of the rear end hit the curb and stopped me, bending the rear end up so I
> got a factory new one under there. Possibly the bracket being pushed so
> hard by the weight of 2 vehicles got a tad bent over? Or maybe the track
> bar folded a bit? I don't know. I'm gonna look around for that stuff again
> today.
>
> I'm about to go remove the front driveshaft and see if the vibes are from
> that or not. I'll let ya'll know what happens!
>
> Troy
rim also?
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> I was on a one way two lane road, making a left turn from the right lane.
> The left lane car should have been making a left turn also but he went
> straight and hit me square in the side as I was turning left. His car was a
> little pos and went under my jeep. Luckily he hit my step bars under the
> door, cuz I didn't get any body damage, but it pushed me sideways (from the
> left) into the curb on my right where I came to a dead stop. The right side
> of the rear end hit the curb and stopped me, bending the rear end up so I
> got a factory new one under there. Possibly the bracket being pushed so
> hard by the weight of 2 vehicles got a tad bent over? Or maybe the track
> bar folded a bit? I don't know. I'm gonna look around for that stuff again
> today.
>
> I'm about to go remove the front driveshaft and see if the vibes are from
> that or not. I'll let ya'll know what happens!
>
> Troy
#64
Guest
Posts: n/a
Re: 4 inch suspension nitpicking
The top end of the track bar might have moved too. Did you get a new
rim also?
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> I was on a one way two lane road, making a left turn from the right lane.
> The left lane car should have been making a left turn also but he went
> straight and hit me square in the side as I was turning left. His car was a
> little pos and went under my jeep. Luckily he hit my step bars under the
> door, cuz I didn't get any body damage, but it pushed me sideways (from the
> left) into the curb on my right where I came to a dead stop. The right side
> of the rear end hit the curb and stopped me, bending the rear end up so I
> got a factory new one under there. Possibly the bracket being pushed so
> hard by the weight of 2 vehicles got a tad bent over? Or maybe the track
> bar folded a bit? I don't know. I'm gonna look around for that stuff again
> today.
>
> I'm about to go remove the front driveshaft and see if the vibes are from
> that or not. I'll let ya'll know what happens!
>
> Troy
rim also?
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Canadian Off Road Trips Photos: Non members can still view!
Jan/06 http://www.imagestation.com/album/pi...?id=2115147590
(More Off Road album links at bottom of the view page)
Troy wrote:
>
> I was on a one way two lane road, making a left turn from the right lane.
> The left lane car should have been making a left turn also but he went
> straight and hit me square in the side as I was turning left. His car was a
> little pos and went under my jeep. Luckily he hit my step bars under the
> door, cuz I didn't get any body damage, but it pushed me sideways (from the
> left) into the curb on my right where I came to a dead stop. The right side
> of the rear end hit the curb and stopped me, bending the rear end up so I
> got a factory new one under there. Possibly the bracket being pushed so
> hard by the weight of 2 vehicles got a tad bent over? Or maybe the track
> bar folded a bit? I don't know. I'm gonna look around for that stuff again
> today.
>
> I'm about to go remove the front driveshaft and see if the vibes are from
> that or not. I'll let ya'll know what happens!
>
> Troy
#65
Guest
Posts: n/a
Re: 4 inch suspension nitpicking
Yup got a new rim and 2 new tires outta this. I just got back from working
on it today, took the front shaft off and drove around, didn't figure you
guys would let me just jack up the rear end and put it in gear. I still get
the vibrations though... so it must be somewhere back there. Maybe my
driveshaft is just outta whack, I give up. I'll wait until the shop can
take me in and look at it. I will let you guys know what the culprit is
when they let me know. I'm damn interested in finding out what they have to
say.
Troy
on it today, took the front shaft off and drove around, didn't figure you
guys would let me just jack up the rear end and put it in gear. I still get
the vibrations though... so it must be somewhere back there. Maybe my
driveshaft is just outta whack, I give up. I'll wait until the shop can
take me in and look at it. I will let you guys know what the culprit is
when they let me know. I'm damn interested in finding out what they have to
say.
Troy
#66
Guest
Posts: n/a
Re: 4 inch suspension nitpicking
Yup got a new rim and 2 new tires outta this. I just got back from working
on it today, took the front shaft off and drove around, didn't figure you
guys would let me just jack up the rear end and put it in gear. I still get
the vibrations though... so it must be somewhere back there. Maybe my
driveshaft is just outta whack, I give up. I'll wait until the shop can
take me in and look at it. I will let you guys know what the culprit is
when they let me know. I'm damn interested in finding out what they have to
say.
Troy
on it today, took the front shaft off and drove around, didn't figure you
guys would let me just jack up the rear end and put it in gear. I still get
the vibrations though... so it must be somewhere back there. Maybe my
driveshaft is just outta whack, I give up. I'll wait until the shop can
take me in and look at it. I will let you guys know what the culprit is
when they let me know. I'm damn interested in finding out what they have to
say.
Troy
#67
Guest
Posts: n/a
Re: 4 inch suspension nitpicking
Yup got a new rim and 2 new tires outta this. I just got back from working
on it today, took the front shaft off and drove around, didn't figure you
guys would let me just jack up the rear end and put it in gear. I still get
the vibrations though... so it must be somewhere back there. Maybe my
driveshaft is just outta whack, I give up. I'll wait until the shop can
take me in and look at it. I will let you guys know what the culprit is
when they let me know. I'm damn interested in finding out what they have to
say.
Troy
on it today, took the front shaft off and drove around, didn't figure you
guys would let me just jack up the rear end and put it in gear. I still get
the vibrations though... so it must be somewhere back there. Maybe my
driveshaft is just outta whack, I give up. I'll wait until the shop can
take me in and look at it. I will let you guys know what the culprit is
when they let me know. I'm damn interested in finding out what they have to
say.
Troy