I think your first thing to check is the linkage of the shift lever to the
tcase. This connection is done with a small bolt through a collar, and the
bolt comes loose. It sounds like the bolt has come loose and the tcase is
not engaging the internal forks and stuff to engage the 4WD.





"pauley" <pauleytrapp@hotmail.com> wrote in message
news:afa39abe.0312010800.1aab291@posting.google.co m...
> Went to put my 93 4.0(manual) Sahara into fwd high, and a horrible
> clicking noise came from under the drivers seat when I started
> applying the gas. Sounds like it is at the Tcase(NP231). I was on flat
> soft mud with little resistance. I tryed reverse, same thing. When in
> gear the Jeep would drive, but the clicking told me to stop and put it
> back in 2wd. Runs and shifts normally in 2 wheel high. Where do I
> start with this one without putting it in the shop? Any help would be
> greatly appreciated, snow is on it's way here in the NE.

 

I think your first thing to check is the linkage of the shift lever to the
tcase. This connection is done with a small bolt through a collar, and the
bolt comes loose. It sounds like the bolt has come loose and the tcase is
not engaging the internal forks and stuff to engage the 4WD.





"pauley" <pauleytrapp@hotmail.com> wrote in message
news:afa39abe.0312010800.1aab291@posting.google.co m...
> Went to put my 93 4.0(manual) Sahara into fwd high, and a horrible
> clicking noise came from under the drivers seat when I started
> applying the gas. Sounds like it is at the Tcase(NP231). I was on flat
> soft mud with little resistance. I tryed reverse, same thing. When in
> gear the Jeep would drive, but the clicking told me to stop and put it
> back in 2wd. Runs and shifts normally in 2 wheel high. Where do I
> start with this one without putting it in the shop? Any help would be
> greatly appreciated, snow is on it's way here in the NE.

 

I think your first thing to check is the linkage of the shift lever to the
tcase. This connection is done with a small bolt through a collar, and the
bolt comes loose. It sounds like the bolt has come loose and the tcase is
not engaging the internal forks and stuff to engage the 4WD.





"pauley" <pauleytrapp@hotmail.com> wrote in message
news:afa39abe.0312010800.1aab291@posting.google.co m...
> Went to put my 93 4.0(manual) Sahara into fwd high, and a horrible
> clicking noise came from under the drivers seat when I started
> applying the gas. Sounds like it is at the Tcase(NP231). I was on flat
> soft mud with little resistance. I tryed reverse, same thing. When in
> gear the Jeep would drive, but the clicking told me to stop and put it
> back in 2wd. Runs and shifts normally in 2 wheel high. Where do I
> start with this one without putting it in the shop? Any help would be
> greatly appreciated, snow is on it's way here in the NE.