To Do list...
09-28-2007, 12:26 PM
#31
Guest
Posts: n/a
Re: To Do list...
On Sep 24, 9:26 pm, "Carl S" <carlsai...@REMOVE.hotmail.com> wrote:
> OK gang, here's my To Do list...
>
> Install rear locker -Have parts
>
> Install TNT frame stiffeners - In mail, then @ painters
>
> Install AJ's super rails - In mail, then @ painters
>
> Install new Hella 550 fog lamps - Have parts
>
> Install front and rear tow hooks - In mail
>
> Fabricate cowl vent intake - Still designing/fabbing flanges
>
> Front brakes and front axle U joints - Need to buy parts
>
> Rebuild new (boneyard) front driveshaft, (new u joints and centering yoke,
> have balance checked, ect), figure out front driveshaft clearance issue
> (more on this later) - Need to buy c-yoke and u joints
>
> Get rear driveshaft converted to CV - In the works
>
> Find/make t-case skid plate - Located one I like
>
> Wheel!!!! - Need gas and time!!
>
> What's on your list?
>
> Carl
Well, quite a few things:
1) fix electrical delayed start problem
2) replace lower bearing on steering shaft
3) fix rust holes in floor
6) fab rock sliders from 4x4 angle iron
7) convert gas tank to 20 gallons
8) and the things that will be on hold till next summer: lift, SYE and
CV DS.
The Jeep project never ends!
> OK gang, here's my To Do list...
>
> Install rear locker -Have parts
>
> Install TNT frame stiffeners - In mail, then @ painters
>
> Install AJ's super rails - In mail, then @ painters
>
> Install new Hella 550 fog lamps - Have parts
>
> Install front and rear tow hooks - In mail
>
> Fabricate cowl vent intake - Still designing/fabbing flanges
>
> Front brakes and front axle U joints - Need to buy parts
>
> Rebuild new (boneyard) front driveshaft, (new u joints and centering yoke,
> have balance checked, ect), figure out front driveshaft clearance issue
> (more on this later) - Need to buy c-yoke and u joints
>
> Get rear driveshaft converted to CV - In the works
>
> Find/make t-case skid plate - Located one I like
>
> Wheel!!!! - Need gas and time!!
>
> What's on your list?
>
> Carl
Well, quite a few things:
1) fix electrical delayed start problem
2) replace lower bearing on steering shaft
3) fix rust holes in floor
6) fab rock sliders from 4x4 angle iron
7) convert gas tank to 20 gallons
8) and the things that will be on hold till next summer: lift, SYE and
CV DS.
The Jeep project never ends!
09-28-2007, 12:26 PM
#32
Guest
Posts: n/a
Re: To Do list...
On Sep 24, 9:26 pm, "Carl S" <carlsai...@REMOVE.hotmail.com> wrote:
> OK gang, here's my To Do list...
>
> Install rear locker -Have parts
>
> Install TNT frame stiffeners - In mail, then @ painters
>
> Install AJ's super rails - In mail, then @ painters
>
> Install new Hella 550 fog lamps - Have parts
>
> Install front and rear tow hooks - In mail
>
> Fabricate cowl vent intake - Still designing/fabbing flanges
>
> Front brakes and front axle U joints - Need to buy parts
>
> Rebuild new (boneyard) front driveshaft, (new u joints and centering yoke,
> have balance checked, ect), figure out front driveshaft clearance issue
> (more on this later) - Need to buy c-yoke and u joints
>
> Get rear driveshaft converted to CV - In the works
>
> Find/make t-case skid plate - Located one I like
>
> Wheel!!!! - Need gas and time!!
>
> What's on your list?
>
> Carl
Well, quite a few things:
1) fix electrical delayed start problem
2) replace lower bearing on steering shaft
3) fix rust holes in floor
6) fab rock sliders from 4x4 angle iron
7) convert gas tank to 20 gallons
8) and the things that will be on hold till next summer: lift, SYE and
CV DS.
The Jeep project never ends!
> OK gang, here's my To Do list...
>
> Install rear locker -Have parts
>
> Install TNT frame stiffeners - In mail, then @ painters
>
> Install AJ's super rails - In mail, then @ painters
>
> Install new Hella 550 fog lamps - Have parts
>
> Install front and rear tow hooks - In mail
>
> Fabricate cowl vent intake - Still designing/fabbing flanges
>
> Front brakes and front axle U joints - Need to buy parts
>
> Rebuild new (boneyard) front driveshaft, (new u joints and centering yoke,
> have balance checked, ect), figure out front driveshaft clearance issue
> (more on this later) - Need to buy c-yoke and u joints
>
> Get rear driveshaft converted to CV - In the works
>
> Find/make t-case skid plate - Located one I like
>
> Wheel!!!! - Need gas and time!!
>
> What's on your list?
>
> Carl
Well, quite a few things:
1) fix electrical delayed start problem
2) replace lower bearing on steering shaft
3) fix rust holes in floor
6) fab rock sliders from 4x4 angle iron
7) convert gas tank to 20 gallons
8) and the things that will be on hold till next summer: lift, SYE and
CV DS.
The Jeep project never ends!
09-28-2007, 12:26 PM
#33
Guest
Posts: n/a
Re: To Do list...
On Sep 24, 9:26 pm, "Carl S" <carlsai...@REMOVE.hotmail.com> wrote:
> OK gang, here's my To Do list...
>
> Install rear locker -Have parts
>
> Install TNT frame stiffeners - In mail, then @ painters
>
> Install AJ's super rails - In mail, then @ painters
>
> Install new Hella 550 fog lamps - Have parts
>
> Install front and rear tow hooks - In mail
>
> Fabricate cowl vent intake - Still designing/fabbing flanges
>
> Front brakes and front axle U joints - Need to buy parts
>
> Rebuild new (boneyard) front driveshaft, (new u joints and centering yoke,
> have balance checked, ect), figure out front driveshaft clearance issue
> (more on this later) - Need to buy c-yoke and u joints
>
> Get rear driveshaft converted to CV - In the works
>
> Find/make t-case skid plate - Located one I like
>
> Wheel!!!! - Need gas and time!!
>
> What's on your list?
>
> Carl
Well, quite a few things:
1) fix electrical delayed start problem
2) replace lower bearing on steering shaft
3) fix rust holes in floor
6) fab rock sliders from 4x4 angle iron
7) convert gas tank to 20 gallons
8) and the things that will be on hold till next summer: lift, SYE and
CV DS.
The Jeep project never ends!
> OK gang, here's my To Do list...
>
> Install rear locker -Have parts
>
> Install TNT frame stiffeners - In mail, then @ painters
>
> Install AJ's super rails - In mail, then @ painters
>
> Install new Hella 550 fog lamps - Have parts
>
> Install front and rear tow hooks - In mail
>
> Fabricate cowl vent intake - Still designing/fabbing flanges
>
> Front brakes and front axle U joints - Need to buy parts
>
> Rebuild new (boneyard) front driveshaft, (new u joints and centering yoke,
> have balance checked, ect), figure out front driveshaft clearance issue
> (more on this later) - Need to buy c-yoke and u joints
>
> Get rear driveshaft converted to CV - In the works
>
> Find/make t-case skid plate - Located one I like
>
> Wheel!!!! - Need gas and time!!
>
> What's on your list?
>
> Carl
Well, quite a few things:
1) fix electrical delayed start problem
2) replace lower bearing on steering shaft
3) fix rust holes in floor
6) fab rock sliders from 4x4 angle iron
7) convert gas tank to 20 gallons
8) and the things that will be on hold till next summer: lift, SYE and
CV DS.
The Jeep project never ends!
10-02-2007, 02:15 PM
#34
Guest
Posts: n/a
Re: To Do list...
"Carl S" <carlsaiyed@REMOVE.hotmail.com> wrote in message
news:UoudnVwfvMTXAmHbnZ2dnUVZ_jydnZ2d@comcast.com. ..
Kate,
I have heard of guys turning the battery sideways and installing two
optima's. The optima's are great b/c you can mount them sideways or upside
down and they are much more resitant to shock then a traditional battery.
How's the house project coming?
Carl
The house is coning along..
I am about sick to death of it and the projects seem to take longer and
longer.
Only a couple of finishing up touch things to doand then I'm quitting for a
few years.
I'm ready to spend my money ND my time doing something a lot more fun.
Kate
10-02-2007, 02:15 PM
#35
Guest
Posts: n/a
Re: To Do list...
"Carl S" <carlsaiyed@REMOVE.hotmail.com> wrote in message
news:UoudnVwfvMTXAmHbnZ2dnUVZ_jydnZ2d@comcast.com. ..
Kate,
I have heard of guys turning the battery sideways and installing two
optima's. The optima's are great b/c you can mount them sideways or upside
down and they are much more resitant to shock then a traditional battery.
How's the house project coming?
Carl
The house is coning along..
I am about sick to death of it and the projects seem to take longer and
longer.
Only a couple of finishing up touch things to doand then I'm quitting for a
few years.
I'm ready to spend my money ND my time doing something a lot more fun.
Kate
10-02-2007, 02:15 PM
#36
Guest
Posts: n/a
Re: To Do list...
"Carl S" <carlsaiyed@REMOVE.hotmail.com> wrote in message
news:UoudnVwfvMTXAmHbnZ2dnUVZ_jydnZ2d@comcast.com. ..
Kate,
I have heard of guys turning the battery sideways and installing two
optima's. The optima's are great b/c you can mount them sideways or upside
down and they are much more resitant to shock then a traditional battery.
How's the house project coming?
Carl
The house is coning along..
I am about sick to death of it and the projects seem to take longer and
longer.
Only a couple of finishing up touch things to doand then I'm quitting for a
few years.
I'm ready to spend my money ND my time doing something a lot more fun.
Kate
10-02-2007, 02:15 PM
#37
Guest
Posts: n/a
Re: To Do list...
"Carl S" <carlsaiyed@REMOVE.hotmail.com> wrote in message
news:UoudnVwfvMTXAmHbnZ2dnUVZ_jydnZ2d@comcast.com. ..
Kate,
I have heard of guys turning the battery sideways and installing two
optima's. The optima's are great b/c you can mount them sideways or upside
down and they are much more resitant to shock then a traditional battery.
How's the house project coming?
Carl
The house is coning along..
I am about sick to death of it and the projects seem to take longer and
longer.
Only a couple of finishing up touch things to doand then I'm quitting for a
few years.
I'm ready to spend my money ND my time doing something a lot more fun.
Kate
Thread
Thread Starter
Forum
Replies
Last Post
Paul Tremblay
Jeep Mailing List
32
05-04-2004 11:06 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)