Charcoal Canister Off-Now What
10-17-2005, 11:45 PM
#21
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
Ok then I have been working on this all night.
I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
The PCV was not hooked up and another post covered it.
Where does the dist vac go? Mine is running into the bottom of the
carb on the valve cover side. Is that correct, I don't see how it
could be.
I have an 86 CJ7 w/258 & Weber.
Thanks so much!
I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
The PCV was not hooked up and another post covered it.
Where does the dist vac go? Mine is running into the bottom of the
carb on the valve cover side. Is that correct, I don't see how it
could be.
I have an 86 CJ7 w/258 & Weber.
Thanks so much!
10-17-2005, 11:45 PM
#22
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
Ok then I have been working on this all night.
I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
The PCV was not hooked up and another post covered it.
Where does the dist vac go? Mine is running into the bottom of the
carb on the valve cover side. Is that correct, I don't see how it
could be.
I have an 86 CJ7 w/258 & Weber.
Thanks so much!
I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
The PCV was not hooked up and another post covered it.
Where does the dist vac go? Mine is running into the bottom of the
carb on the valve cover side. Is that correct, I don't see how it
could be.
I have an 86 CJ7 w/258 & Weber.
Thanks so much!
10-18-2005, 10:02 AM
#23
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
Is yours dead? Does the idle go nuts when you plug in the PCV line and
leave the distributor vacuum off?
They 'are' available aftermarket. I do not remember where, but it has
been posted here before.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Where can get a new one, Jeep says they are discontinued?????????
leave the distributor vacuum off?
They 'are' available aftermarket. I do not remember where, but it has
been posted here before.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Where can get a new one, Jeep says they are discontinued?????????
10-18-2005, 10:02 AM
#24
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
Is yours dead? Does the idle go nuts when you plug in the PCV line and
leave the distributor vacuum off?
They 'are' available aftermarket. I do not remember where, but it has
been posted here before.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Where can get a new one, Jeep says they are discontinued?????????
leave the distributor vacuum off?
They 'are' available aftermarket. I do not remember where, but it has
been posted here before.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Where can get a new one, Jeep says they are discontinued?????????
10-18-2005, 10:02 AM
#25
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
Is yours dead? Does the idle go nuts when you plug in the PCV line and
leave the distributor vacuum off?
They 'are' available aftermarket. I do not remember where, but it has
been posted here before.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Where can get a new one, Jeep says they are discontinued?????????
leave the distributor vacuum off?
They 'are' available aftermarket. I do not remember where, but it has
been posted here before.
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Where can get a new one, Jeep says they are discontinued?????????
10-18-2005, 10:09 AM
#26
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
The 'ported' vacuum on the stock BBD carb is on the valve cover side
about half way up. This is for the distributor advance (with no
computer) and the charcoal canister and the EGR.
'Usually' the line comes out of the ported nipple, then has a T
fitting. One way on the T goes to the distributor, the other way goes
to the CTO valve and from there to another T fitting. From this one
line goes to the canister, the other to the air filter's switch for the
EGR valve and from there to the EGR.
Here is a good site on the vacuum lines and other junk:
http://home.sprynet.com/~dale02/vacuhose.htm
http://home.sprynet.com/~dale02/list.htm
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Ok then I have been working on this all night.
>
> I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
>
> The PCV was not hooked up and another post covered it.
>
> Where does the dist vac go? Mine is running into the bottom of the
> carb on the valve cover side. Is that correct, I don't see how it
> could be.
>
> I have an 86 CJ7 w/258 & Weber.
>
> Thanks so much!
about half way up. This is for the distributor advance (with no
computer) and the charcoal canister and the EGR.
'Usually' the line comes out of the ported nipple, then has a T
fitting. One way on the T goes to the distributor, the other way goes
to the CTO valve and from there to another T fitting. From this one
line goes to the canister, the other to the air filter's switch for the
EGR valve and from there to the EGR.
Here is a good site on the vacuum lines and other junk:
http://home.sprynet.com/~dale02/vacuhose.htm
http://home.sprynet.com/~dale02/list.htm
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Ok then I have been working on this all night.
>
> I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
>
> The PCV was not hooked up and another post covered it.
>
> Where does the dist vac go? Mine is running into the bottom of the
> carb on the valve cover side. Is that correct, I don't see how it
> could be.
>
> I have an 86 CJ7 w/258 & Weber.
>
> Thanks so much!
10-18-2005, 10:09 AM
#27
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
The 'ported' vacuum on the stock BBD carb is on the valve cover side
about half way up. This is for the distributor advance (with no
computer) and the charcoal canister and the EGR.
'Usually' the line comes out of the ported nipple, then has a T
fitting. One way on the T goes to the distributor, the other way goes
to the CTO valve and from there to another T fitting. From this one
line goes to the canister, the other to the air filter's switch for the
EGR valve and from there to the EGR.
Here is a good site on the vacuum lines and other junk:
http://home.sprynet.com/~dale02/vacuhose.htm
http://home.sprynet.com/~dale02/list.htm
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Ok then I have been working on this all night.
>
> I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
>
> The PCV was not hooked up and another post covered it.
>
> Where does the dist vac go? Mine is running into the bottom of the
> carb on the valve cover side. Is that correct, I don't see how it
> could be.
>
> I have an 86 CJ7 w/258 & Weber.
>
> Thanks so much!
about half way up. This is for the distributor advance (with no
computer) and the charcoal canister and the EGR.
'Usually' the line comes out of the ported nipple, then has a T
fitting. One way on the T goes to the distributor, the other way goes
to the CTO valve and from there to another T fitting. From this one
line goes to the canister, the other to the air filter's switch for the
EGR valve and from there to the EGR.
Here is a good site on the vacuum lines and other junk:
http://home.sprynet.com/~dale02/vacuhose.htm
http://home.sprynet.com/~dale02/list.htm
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Ok then I have been working on this all night.
>
> I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
>
> The PCV was not hooked up and another post covered it.
>
> Where does the dist vac go? Mine is running into the bottom of the
> carb on the valve cover side. Is that correct, I don't see how it
> could be.
>
> I have an 86 CJ7 w/258 & Weber.
>
> Thanks so much!
10-18-2005, 10:09 AM
#28
Guest
Posts: n/a
Re: Charcoal Canister Off-Now What
The 'ported' vacuum on the stock BBD carb is on the valve cover side
about half way up. This is for the distributor advance (with no
computer) and the charcoal canister and the EGR.
'Usually' the line comes out of the ported nipple, then has a T
fitting. One way on the T goes to the distributor, the other way goes
to the CTO valve and from there to another T fitting. From this one
line goes to the canister, the other to the air filter's switch for the
EGR valve and from there to the EGR.
Here is a good site on the vacuum lines and other junk:
http://home.sprynet.com/~dale02/vacuhose.htm
http://home.sprynet.com/~dale02/list.htm
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Ok then I have been working on this all night.
>
> I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
>
> The PCV was not hooked up and another post covered it.
>
> Where does the dist vac go? Mine is running into the bottom of the
> carb on the valve cover side. Is that correct, I don't see how it
> could be.
>
> I have an 86 CJ7 w/258 & Weber.
>
> Thanks so much!
about half way up. This is for the distributor advance (with no
computer) and the charcoal canister and the EGR.
'Usually' the line comes out of the ported nipple, then has a T
fitting. One way on the T goes to the distributor, the other way goes
to the CTO valve and from there to another T fitting. From this one
line goes to the canister, the other to the air filter's switch for the
EGR valve and from there to the EGR.
Here is a good site on the vacuum lines and other junk:
http://home.sprynet.com/~dale02/vacuhose.htm
http://home.sprynet.com/~dale02/list.htm
Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's
Jack-Jack wrote:
>
> Ok then I have been working on this all night.
>
> I have 4 outlets on the canister...tank, carb float, PCV & dist vac.
>
> The PCV was not hooked up and another post covered it.
>
> Where does the dist vac go? Mine is running into the bottom of the
> carb on the valve cover side. Is that correct, I don't see how it
> could be.
>
> I have an 86 CJ7 w/258 & Weber.
>
> Thanks so much!
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)