AMC 20 - leaking seal
07-21-2006, 12:15 AM
#1
Guest
Posts: n/a
AMC 20 - leaking seal
Got back from an off road event this past weekend and noticed my pass
side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
Detroit Locker) is leaking.
Talked to Moser and they confirmed it should take a stock replacement
seal (or seals plural - "depending").
Anyone got a quick link (Bill?) to some instructional "how to do it"
for replacing the seal - or a some reply guidance on "how to do it".
Thanks
Lynn in Vancouver WA
side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
Detroit Locker) is leaking.
Talked to Moser and they confirmed it should take a stock replacement
seal (or seals plural - "depending").
Anyone got a quick link (Bill?) to some instructional "how to do it"
for replacing the seal - or a some reply guidance on "how to do it".
Thanks
Lynn in Vancouver WA
07-21-2006, 12:39 AM
#2
Guest
Posts: n/a
Re: AMC 20 - leaking seal
Hi Lynn,
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
07-21-2006, 12:39 AM
#3
Guest
Posts: n/a
Re: AMC 20 - leaking seal
Hi Lynn,
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
07-21-2006, 12:39 AM
#4
Guest
Posts: n/a
Re: AMC 20 - leaking seal
Hi Lynn,
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
07-21-2006, 12:39 AM
#5
Guest
Posts: n/a
Re: AMC 20 - leaking seal
Hi Lynn,
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
Should be basically the same as a Dana 44, go thought the flange to
unbolt the retainer and backing plate. Use a slide hammer or length of
chain attached to a lug to throw out and the axle will follow. Check the
bearing as that may be your problem, replace if it has a rusty film
covering a sealed until. Make a driver with bolts and a washer about the
same size as the seal to drive it in straight:
http://www.4x4wire.com/jeep/tech/axle/superior02/
God Bless America, Bill O|||||||O
mailto:-------------------- http://www.----------.com/
"lynnhowlyn@aol.com" wrote:
>
> Got back from an off road event this past weekend and noticed my pass
> side rear axle seal (Wide Track AMC 20 Moser 1-piece axles, 4.11's,
> Detroit Locker) is leaking.
>
> Talked to Moser and they confirmed it should take a stock replacement
> seal (or seals plural - "depending").
>
> Anyone got a quick link (Bill?) to some instructional "how to do it"
> for replacing the seal - or a some reply guidance on "how to do it".
>
> Thanks
> Lynn in Vancouver WA
Thread
Thread Starter
Forum
Replies
Last Post
alexmacpherson@rogers.com
Jeep Mailing List
6
03-17-2007 12:32 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
