93 Zj Alarm issues, help needed
Guest
Posts: n/a
93 Zj Alarm issues, help needed
The wifeys 93 ZJ has othat $%^& factory alarm on it, which has decided
to "go off" for no reason, sometimes during the day other times during
the night.
I want to check the connectors for moisture, but on a quick look I was
unable to locate or identify the alarm connectors. where are they??
and is there anyway to disable the factory alarm??
TIA
Snow...
to "go off" for no reason, sometimes during the day other times during
the night.
I want to check the connectors for moisture, but on a quick look I was
unable to locate or identify the alarm connectors. where are they??
and is there anyway to disable the factory alarm??
TIA
Snow...
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
Snow wrote:
> The wifeys 93 ZJ has othat $%^& factory alarm on it, which has decided
> to "go off" for no reason, sometimes during the day other times during
> the night.
>
> I want to check the connectors for moisture, but on a quick look I was
> unable to locate or identify the alarm connectors. where are they??
> and is there anyway to disable the factory alarm??
The alarm sensor that usually goes bad is the hood sensor.
It's the only dedicated sensor in the system. The rest just
uses interior lights.
They put the stupid thing right where water drains and it
corrodes. It's over by the battery. Just pull the wire
off and tape it so it doesn't hit the frame.
As for disabling it, no. The thing is too tightly tied into
the vehicle. It communicates with the ECU and if you remove
the SAM the ZJ won't start.
http://www.revbeergoggles.com/temp/zj-8w-108.jpg
http://www.revbeergoggles.com/temp/zj-8w-109.jpg
If those are too fuzzy to read, let me know.
--
DougW
> The wifeys 93 ZJ has othat $%^& factory alarm on it, which has decided
> to "go off" for no reason, sometimes during the day other times during
> the night.
>
> I want to check the connectors for moisture, but on a quick look I was
> unable to locate or identify the alarm connectors. where are they??
> and is there anyway to disable the factory alarm??
The alarm sensor that usually goes bad is the hood sensor.
It's the only dedicated sensor in the system. The rest just
uses interior lights.
They put the stupid thing right where water drains and it
corrodes. It's over by the battery. Just pull the wire
off and tape it so it doesn't hit the frame.
As for disabling it, no. The thing is too tightly tied into
the vehicle. It communicates with the ECU and if you remove
the SAM the ZJ won't start.
http://www.revbeergoggles.com/temp/zj-8w-108.jpg
http://www.revbeergoggles.com/temp/zj-8w-109.jpg
If those are too fuzzy to read, let me know.
--
DougW
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
Snow wrote:
> The wifeys 93 ZJ has othat $%^& factory alarm on it, which has decided
> to "go off" for no reason, sometimes during the day other times during
> the night.
>
> I want to check the connectors for moisture, but on a quick look I was
> unable to locate or identify the alarm connectors. where are they??
> and is there anyway to disable the factory alarm??
The alarm sensor that usually goes bad is the hood sensor.
It's the only dedicated sensor in the system. The rest just
uses interior lights.
They put the stupid thing right where water drains and it
corrodes. It's over by the battery. Just pull the wire
off and tape it so it doesn't hit the frame.
As for disabling it, no. The thing is too tightly tied into
the vehicle. It communicates with the ECU and if you remove
the SAM the ZJ won't start.
http://www.revbeergoggles.com/temp/zj-8w-108.jpg
http://www.revbeergoggles.com/temp/zj-8w-109.jpg
If those are too fuzzy to read, let me know.
--
DougW
> The wifeys 93 ZJ has othat $%^& factory alarm on it, which has decided
> to "go off" for no reason, sometimes during the day other times during
> the night.
>
> I want to check the connectors for moisture, but on a quick look I was
> unable to locate or identify the alarm connectors. where are they??
> and is there anyway to disable the factory alarm??
The alarm sensor that usually goes bad is the hood sensor.
It's the only dedicated sensor in the system. The rest just
uses interior lights.
They put the stupid thing right where water drains and it
corrodes. It's over by the battery. Just pull the wire
off and tape it so it doesn't hit the frame.
As for disabling it, no. The thing is too tightly tied into
the vehicle. It communicates with the ECU and if you remove
the SAM the ZJ won't start.
http://www.revbeergoggles.com/temp/zj-8w-108.jpg
http://www.revbeergoggles.com/temp/zj-8w-109.jpg
If those are too fuzzy to read, let me know.
--
DougW
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
Snow wrote:
> The wifeys 93 ZJ has othat $%^& factory alarm on it, which has decided
> to "go off" for no reason, sometimes during the day other times during
> the night.
>
> I want to check the connectors for moisture, but on a quick look I was
> unable to locate or identify the alarm connectors. where are they??
> and is there anyway to disable the factory alarm??
The alarm sensor that usually goes bad is the hood sensor.
It's the only dedicated sensor in the system. The rest just
uses interior lights.
They put the stupid thing right where water drains and it
corrodes. It's over by the battery. Just pull the wire
off and tape it so it doesn't hit the frame.
As for disabling it, no. The thing is too tightly tied into
the vehicle. It communicates with the ECU and if you remove
the SAM the ZJ won't start.
http://www.revbeergoggles.com/temp/zj-8w-108.jpg
http://www.revbeergoggles.com/temp/zj-8w-109.jpg
If those are too fuzzy to read, let me know.
--
DougW
> The wifeys 93 ZJ has othat $%^& factory alarm on it, which has decided
> to "go off" for no reason, sometimes during the day other times during
> the night.
>
> I want to check the connectors for moisture, but on a quick look I was
> unable to locate or identify the alarm connectors. where are they??
> and is there anyway to disable the factory alarm??
The alarm sensor that usually goes bad is the hood sensor.
It's the only dedicated sensor in the system. The rest just
uses interior lights.
They put the stupid thing right where water drains and it
corrodes. It's over by the battery. Just pull the wire
off and tape it so it doesn't hit the frame.
As for disabling it, no. The thing is too tightly tied into
the vehicle. It communicates with the ECU and if you remove
the SAM the ZJ won't start.
http://www.revbeergoggles.com/temp/zj-8w-108.jpg
http://www.revbeergoggles.com/temp/zj-8w-109.jpg
If those are too fuzzy to read, let me know.
--
DougW
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
> and is there anyway to disable the factory alarm??
There's a purple wire with a yellow tracer near the driver's side kickpanel.
Ground that and the alarm is disabled.
Actually I found two on mine when I installed my remote starter, but both
went to the same pin on the connector.
--
Posted via a free Usenet account from http://www.teranews.com
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
> and is there anyway to disable the factory alarm??
There's a purple wire with a yellow tracer near the driver's side kickpanel.
Ground that and the alarm is disabled.
Actually I found two on mine when I installed my remote starter, but both
went to the same pin on the connector.
--
Posted via a free Usenet account from http://www.teranews.com
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
> and is there anyway to disable the factory alarm??
There's a purple wire with a yellow tracer near the driver's side kickpanel.
Ground that and the alarm is disabled.
Actually I found two on mine when I installed my remote starter, but both
went to the same pin on the connector.
--
Posted via a free Usenet account from http://www.teranews.com
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
SBlackfoot wrote:
>> and is there anyway to disable the factory alarm??
>
>
> There's a purple wire with a yellow tracer near the driver's side
> kickpanel. Ground that and the alarm is disabled.
>
> Actually I found two on mine when I installed my remote starter, but
> both went to the same pin on the connector.
Ah.. I sit corrected. Good call.
That's actually the 20Ga Violet wire with yellow tracer that
shows up on page 109. It runs to the disarm switches in the
doors.
When I put my aftermarket alarm in, I kept the stock one but
attached the secondary disarm output from the Clifford to the
that wire on the stock system.
--
DougW
>> and is there anyway to disable the factory alarm??
>
>
> There's a purple wire with a yellow tracer near the driver's side
> kickpanel. Ground that and the alarm is disabled.
>
> Actually I found two on mine when I installed my remote starter, but
> both went to the same pin on the connector.
Ah.. I sit corrected. Good call.
That's actually the 20Ga Violet wire with yellow tracer that
shows up on page 109. It runs to the disarm switches in the
doors.
When I put my aftermarket alarm in, I kept the stock one but
attached the secondary disarm output from the Clifford to the
that wire on the stock system.
--
DougW
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
SBlackfoot wrote:
>> and is there anyway to disable the factory alarm??
>
>
> There's a purple wire with a yellow tracer near the driver's side
> kickpanel. Ground that and the alarm is disabled.
>
> Actually I found two on mine when I installed my remote starter, but
> both went to the same pin on the connector.
Ah.. I sit corrected. Good call.
That's actually the 20Ga Violet wire with yellow tracer that
shows up on page 109. It runs to the disarm switches in the
doors.
When I put my aftermarket alarm in, I kept the stock one but
attached the secondary disarm output from the Clifford to the
that wire on the stock system.
--
DougW
>> and is there anyway to disable the factory alarm??
>
>
> There's a purple wire with a yellow tracer near the driver's side
> kickpanel. Ground that and the alarm is disabled.
>
> Actually I found two on mine when I installed my remote starter, but
> both went to the same pin on the connector.
Ah.. I sit corrected. Good call.
That's actually the 20Ga Violet wire with yellow tracer that
shows up on page 109. It runs to the disarm switches in the
doors.
When I put my aftermarket alarm in, I kept the stock one but
attached the secondary disarm output from the Clifford to the
that wire on the stock system.
--
DougW
Guest
Posts: n/a
Re: 93 Zj Alarm issues, help needed
SBlackfoot wrote:
>> and is there anyway to disable the factory alarm??
>
>
> There's a purple wire with a yellow tracer near the driver's side
> kickpanel. Ground that and the alarm is disabled.
>
> Actually I found two on mine when I installed my remote starter, but
> both went to the same pin on the connector.
Ah.. I sit corrected. Good call.
That's actually the 20Ga Violet wire with yellow tracer that
shows up on page 109. It runs to the disarm switches in the
doors.
When I put my aftermarket alarm in, I kept the stock one but
attached the secondary disarm output from the Clifford to the
that wire on the stock system.
--
DougW
>> and is there anyway to disable the factory alarm??
>
>
> There's a purple wire with a yellow tracer near the driver's side
> kickpanel. Ground that and the alarm is disabled.
>
> Actually I found two on mine when I installed my remote starter, but
> both went to the same pin on the connector.
Ah.. I sit corrected. Good call.
That's actually the 20Ga Violet wire with yellow tracer that
shows up on page 109. It runs to the disarm switches in the
doors.
When I put my aftermarket alarm in, I kept the stock one but
attached the secondary disarm output from the Clifford to the
that wire on the stock system.
--
DougW
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)