transfer case swap
#3
Re: transfer case swap
If a 242 is put in there's no issue with the VIC? cause I've got one of those. Also do you know if there's any other issues like spline count, or slip yolk eliminator or having to change the rear driveshaft?
#4
Re: transfer case swap
The VIC will work fine with a 242, only need to swap some wires behind the VIC. I did the 249 to 242 swap twice and never had to change anything. If you get a 242 out of a 96-98 Grand Cherokee or 99-01 Cherokee XJ it should be a direct swap.
#6
Re: transfer case swap
If your 249 is working with your lift then you should not have a problem with the 242. Behind the VIC in the wiring harness you'll find a set of two wire red connectors that you will need to unplug and leave unplugged. In that same wiring harness (might need to un-tape the harness a little) You will find two single wire black connectors which are unplugged, plug the two black connectors into each other.
Thread
Thread Starter
Forum
Replies
Last Post
James Nipper
Jeep Mailing List
12
09-02-2003 02:53 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)