Well I started to tear down my TJ and have ordered my tube fenders. Looking to get a little more tire clearance. I have to say getting the old fender flares off seamed to be a challenge as most of the screws on the driver side would not come out. For a min I though they just pooped out and found out the hard way that they don't and made some small marks on the rear fender. On another note went to take the tires off to make it easier to remove the fenders and had completely broke my Locking Key to the lock nuts. So here I am no having to call the company to get a new key to remove the tires. What a pain in the but. I will have to wait to get a new key and then I will be buying new lug nuts so this never happens again. Will post a couple of pic when I figure out how.

 

Here are some Pics

 

Well here is the fit and the finish after putting the 35 on the jeep. It was a long project but I like the look of it. I will post more photos of it in the bush this weekend.

 

Very nice, Hard install? Also where did you order your kit?

 

It was not that bad to install. I took a little imagination cause the instructions are really not that great but if you decided to order it I ordered it from North Ridge 4X4 Alberta. If you do order the kit it is a genright and make sure you order the inner fender kit to go along with it. At the rear I did need to trim out the rear fender wells a little after it first run but still finished up all good.