Turn Signals & Flashers don't work - 99 Grand Cherokee
03-09-2005, 02:00 PM
#1
Guest
Posts: n/a
Turn Signals & Flashers don't work - 99 Grand Cherokee
Problem started with Left signal working intermittantly, then quit
completely. Now signals and flashers don't work. Changed switch, fuse and
flasher, still not working. Is there a relay I'm not finding? Any help
would be appreciated.
completely. Now signals and flashers don't work. Changed switch, fuse and
flasher, still not working. Is there a relay I'm not finding? Any help
would be appreciated.
03-09-2005, 07:11 PM
#2
Guest
Posts: n/a
Re: Turn Signals & Flashers don't work - 99 Grand Cherokee
Too many things went wrong at the same time, it's got to be in the
switch you replaced. But, I'd start by pulling a bulb and check for
voltage and whether that socket was grounded, with all that plastic one
ground wire could disconnect the whole front end. Then test for power
and continuity at the flasher's socket pin holes. Schematics:
http://www.----------.com/WJTurnSignal.pdf
God Bless America, ßill O|||||||O
mailto:--------------------
RDS1024 wrote:
>
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
switch you replaced. But, I'd start by pulling a bulb and check for
voltage and whether that socket was grounded, with all that plastic one
ground wire could disconnect the whole front end. Then test for power
and continuity at the flasher's socket pin holes. Schematics:
http://www.----------.com/WJTurnSignal.pdf
God Bless America, ßill O|||||||O
mailto:--------------------
RDS1024 wrote:
>
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
03-09-2005, 07:11 PM
#3
Guest
Posts: n/a
Re: Turn Signals & Flashers don't work - 99 Grand Cherokee
Too many things went wrong at the same time, it's got to be in the
switch you replaced. But, I'd start by pulling a bulb and check for
voltage and whether that socket was grounded, with all that plastic one
ground wire could disconnect the whole front end. Then test for power
and continuity at the flasher's socket pin holes. Schematics:
http://www.----------.com/WJTurnSignal.pdf
God Bless America, ßill O|||||||O
mailto:--------------------
RDS1024 wrote:
>
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
switch you replaced. But, I'd start by pulling a bulb and check for
voltage and whether that socket was grounded, with all that plastic one
ground wire could disconnect the whole front end. Then test for power
and continuity at the flasher's socket pin holes. Schematics:
http://www.----------.com/WJTurnSignal.pdf
God Bless America, ßill O|||||||O
mailto:--------------------
RDS1024 wrote:
>
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
03-09-2005, 07:11 PM
#4
Guest
Posts: n/a
Re: Turn Signals & Flashers don't work - 99 Grand Cherokee
Too many things went wrong at the same time, it's got to be in the
switch you replaced. But, I'd start by pulling a bulb and check for
voltage and whether that socket was grounded, with all that plastic one
ground wire could disconnect the whole front end. Then test for power
and continuity at the flasher's socket pin holes. Schematics:
http://www.----------.com/WJTurnSignal.pdf
God Bless America, ßill O|||||||O
mailto:--------------------
RDS1024 wrote:
>
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
switch you replaced. But, I'd start by pulling a bulb and check for
voltage and whether that socket was grounded, with all that plastic one
ground wire could disconnect the whole front end. Then test for power
and continuity at the flasher's socket pin holes. Schematics:
http://www.----------.com/WJTurnSignal.pdf
God Bless America, ßill O|||||||O
mailto:--------------------
RDS1024 wrote:
>
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
03-09-2005, 09:24 PM
#5
Guest
Posts: n/a
Re: Turn Signals & Flashers don't work - 99 Grand Cherokee
yes there is and there is also a body contol module and the lites run thru
that
so you need to figure out if the switch is sending a signal to that and if it
has one going out to the lites
it may have recorded a fault code in the bcm
RDS1024 wrote:
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
that
so you need to figure out if the switch is sending a signal to that and if it
has one going out to the lites
it may have recorded a fault code in the bcm
RDS1024 wrote:
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
03-09-2005, 09:24 PM
#6
Guest
Posts: n/a
Re: Turn Signals & Flashers don't work - 99 Grand Cherokee
yes there is and there is also a body contol module and the lites run thru
that
so you need to figure out if the switch is sending a signal to that and if it
has one going out to the lites
it may have recorded a fault code in the bcm
RDS1024 wrote:
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
that
so you need to figure out if the switch is sending a signal to that and if it
has one going out to the lites
it may have recorded a fault code in the bcm
RDS1024 wrote:
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
03-09-2005, 09:24 PM
#7
Guest
Posts: n/a
Re: Turn Signals & Flashers don't work - 99 Grand Cherokee
yes there is and there is also a body contol module and the lites run thru
that
so you need to figure out if the switch is sending a signal to that and if it
has one going out to the lites
it may have recorded a fault code in the bcm
RDS1024 wrote:
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
that
so you need to figure out if the switch is sending a signal to that and if it
has one going out to the lites
it may have recorded a fault code in the bcm
RDS1024 wrote:
> Problem started with Left signal working intermittantly, then quit
> completely. Now signals and flashers don't work. Changed switch, fuse and
> flasher, still not working. Is there a relay I'm not finding? Any help
> would be appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
joshmerd@gmail.com
Jeep Mailing List
4
04-24-2007 05:40 PM
Doug
Jeep Mailing List
44
05-29-2005 10:02 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
