My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
of 4wheel drive low. After passing neutral into low it will stay and
when I go it will slip out into neutral again. If I hold the shifter
in place all is ok. It works fine in 4wd regular.

Thanks Hank form pa

 

That can be a symptom of a bad engine or tranny mount.

Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's

Hank wrote:
>
> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
> of 4wheel drive low. After passing neutral into low it will stay and
> when I go it will slip out into neutral again. If I hold the shifter
> in place all is ok. It works fine in 4wd regular.
>
> Thanks Hank form pa

 

That can be a symptom of a bad engine or tranny mount.

Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's

Hank wrote:
>
> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
> of 4wheel drive low. After passing neutral into low it will stay and
> when I go it will slip out into neutral again. If I hold the shifter
> in place all is ok. It works fine in 4wd regular.
>
> Thanks Hank form pa

 

That can be a symptom of a bad engine or tranny mount.

Mike
86/00 CJ7 Laredo, 33x9.5 BFG Muds, 'glass nose to tail in '00
88 Cherokee 235 BFG AT's

Hank wrote:
>
> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
> of 4wheel drive low. After passing neutral into low it will stay and
> when I go it will slip out into neutral again. If I hold the shifter
> in place all is ok. It works fine in 4wd regular.
>
> Thanks Hank form pa

 

My Rubicon will do that half the time if I try to engage low from a stop.
The solution is to either do it (and do it fast - don't pause in neutral at
all) while you are hardly moving or to hold the lever in low until you feel
it catch when you ease off the clutch or give it gas if you have auto. Once
the gears catch it always stays in 4lo just fine.

"Hank" <hakone@ptd.net> wrote in message
news:9149tvo7unv2e8t8jvkdtvdtr8t87p4rib@4ax.com...
> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
> of 4wheel drive low. After passing neutral into low it will stay and
> when I go it will slip out into neutral again. If I hold the shifter
> in place all is ok. It works fine in 4wd regular.
>
> Thanks Hank form pa
>

 

My Rubicon will do that half the time if I try to engage low from a stop.
The solution is to either do it (and do it fast - don't pause in neutral at
all) while you are hardly moving or to hold the lever in low until you feel
it catch when you ease off the clutch or give it gas if you have auto. Once
the gears catch it always stays in 4lo just fine.

"Hank" <hakone@ptd.net> wrote in message
news:9149tvo7unv2e8t8jvkdtvdtr8t87p4rib@4ax.com...
> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
> of 4wheel drive low. After passing neutral into low it will stay and
> when I go it will slip out into neutral again. If I hold the shifter
> in place all is ok. It works fine in 4wd regular.
>
> Thanks Hank form pa
>

 

My Rubicon will do that half the time if I try to engage low from a stop.
The solution is to either do it (and do it fast - don't pause in neutral at
all) while you are hardly moving or to hold the lever in low until you feel
it catch when you ease off the clutch or give it gas if you have auto. Once
the gears catch it always stays in 4lo just fine.

"Hank" <hakone@ptd.net> wrote in message
news:9149tvo7unv2e8t8jvkdtvdtr8t87p4rib@4ax.com...
> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
> of 4wheel drive low. After passing neutral into low it will stay and
> when I go it will slip out into neutral again. If I hold the shifter
> in place all is ok. It works fine in 4wd regular.
>
> Thanks Hank form pa
>

 

My 02 TJ was doing that after I installed my lift. The lever itself
needed to be adjusted, it wasn't anything wrong with the drivetrain.
Quick 60 second fix.


On Mon, 08 Dec 2003 17:00:17 GMT, "jdarg" <jdarg@spam.com> wrote:

>My Rubicon will do that half the time if I try to engage low from a stop.
>The solution is to either do it (and do it fast - don't pause in neutral at
>all) while you are hardly moving or to hold the lever in low until you feel
>it catch when you ease off the clutch or give it gas if you have auto. Once
>the gears catch it always stays in 4lo just fine.
>
>"Hank" <hakone@ptd.net> wrote in message
>news:9149tvo7unv2e8t8jvkdtvdtr8t87p4rib@4ax.com.. .
>> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
>> of 4wheel drive low. After passing neutral into low it will stay and
>> when I go it will slip out into neutral again. If I hold the shifter
>> in place all is ok. It works fine in 4wd regular.
>>
>> Thanks Hank form pa
>>
>

 

My 02 TJ was doing that after I installed my lift. The lever itself
needed to be adjusted, it wasn't anything wrong with the drivetrain.
Quick 60 second fix.


On Mon, 08 Dec 2003 17:00:17 GMT, "jdarg" <jdarg@spam.com> wrote:

>My Rubicon will do that half the time if I try to engage low from a stop.
>The solution is to either do it (and do it fast - don't pause in neutral at
>all) while you are hardly moving or to hold the lever in low until you feel
>it catch when you ease off the clutch or give it gas if you have auto. Once
>the gears catch it always stays in 4lo just fine.
>
>"Hank" <hakone@ptd.net> wrote in message
>news:9149tvo7unv2e8t8jvkdtvdtr8t87p4rib@4ax.com.. .
>> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
>> of 4wheel drive low. After passing neutral into low it will stay and
>> when I go it will slip out into neutral again. If I hold the shifter
>> in place all is ok. It works fine in 4wd regular.
>>
>> Thanks Hank form pa
>>
>

 

My 02 TJ was doing that after I installed my lift. The lever itself
needed to be adjusted, it wasn't anything wrong with the drivetrain.
Quick 60 second fix.


On Mon, 08 Dec 2003 17:00:17 GMT, "jdarg" <jdarg@spam.com> wrote:

>My Rubicon will do that half the time if I try to engage low from a stop.
>The solution is to either do it (and do it fast - don't pause in neutral at
>all) while you are hardly moving or to hold the lever in low until you feel
>it catch when you ease off the clutch or give it gas if you have auto. Once
>the gears catch it always stays in 4lo just fine.
>
>"Hank" <hakone@ptd.net> wrote in message
>news:9149tvo7unv2e8t8jvkdtvdtr8t87p4rib@4ax.com.. .
>> My 95 Jeep Cherokee 4.0 aw4 tranny and np242 transfer case slips out
>> of 4wheel drive low. After passing neutral into low it will stay and
>> when I go it will slip out into neutral again. If I hold the shifter
>> in place all is ok. It works fine in 4wd regular.
>>
>> Thanks Hank form pa
>>
>