Re: Getting Rhinoed... anything I need to be careful of?
#1
Guest
Posts: n/a
Re: Getting Rhinoed... anything I need to be careful of?
Any bolt hole that had a bolt in it to hold the seats down would be good to
avoid.
Be sure to remove the drain plugs, or you will never see them again.
PS
A drain plug is a matter of perspective, they could be fill holes ...
"Ichabod Shagnasti" <murfysflawmy@ppendixalltel.net> wrote in message
news:BX1Oa.13793$J%2.803119@news.alltel.net...
> I'm prepping my '01 TJ for Rhino Lining the tub.... have just about
> everything out now (except the driver & passenger seat & the rear half of
> the center console).
>
> I'm wondering if there is anything I need to be careful of when having the
> Rhino guy do his stuff. I don't want him to cover up anything that I
might
> need to get to later on, but so far, I'm not seeing anything in the tub
that
> would be critical. Are there any bolts, access points, etc. I need to ask
> him to avoid?
>
>
avoid.
Be sure to remove the drain plugs, or you will never see them again.
PS
A drain plug is a matter of perspective, they could be fill holes ...
"Ichabod Shagnasti" <murfysflawmy@ppendixalltel.net> wrote in message
news:BX1Oa.13793$J%2.803119@news.alltel.net...
> I'm prepping my '01 TJ for Rhino Lining the tub.... have just about
> everything out now (except the driver & passenger seat & the rear half of
> the center console).
>
> I'm wondering if there is anything I need to be careful of when having the
> Rhino guy do his stuff. I don't want him to cover up anything that I
might
> need to get to later on, but so far, I'm not seeing anything in the tub
that
> would be critical. Are there any bolts, access points, etc. I need to ask
> him to avoid?
>
>
Thread
Thread Starter
Forum
Replies
Last Post
john63401@yahoo.com
Jeep Mailing List
4
07-07-2003 10:14 PM
Matt Macchiarolo
Jeep Mailing List
0
07-07-2003 04:46 PM
Robert Bills
Jeep Mailing List
1
07-07-2003 02:47 PM
Robert Bills
Jeep Mailing List
2
07-06-2003 10:58 PM
Matt Macchiarolo
Jeep Mailing List
0
07-06-2003 10:35 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)