Note for you 93 ZJ owners with O2 sensor problems.
#1
Guest
Posts: n/a
Note for you 93 ZJ owners with O2 sensor problems.
I found a real nice suprise when doing the header.
The O2 harness runs up past the oil pan then gets held
to the block with a loose clamp.
http://members.***.net/wilsond/temp/holddown.jpg
Look at what engine heat did to the wire inside that
clamp.
http://members.***.net/wilsond/temp/damage.jpg
That explains a lot as to why the sensor checked out
ok (from the sensor connection) but still wasn't reading
right on the DRB.
Wire and solder should fix this but I've got to find
a better route for that wire.
--
DougW
The O2 harness runs up past the oil pan then gets held
to the block with a loose clamp.
http://members.***.net/wilsond/temp/holddown.jpg
Look at what engine heat did to the wire inside that
clamp.
http://members.***.net/wilsond/temp/damage.jpg
That explains a lot as to why the sensor checked out
ok (from the sensor connection) but still wasn't reading
right on the DRB.
Wire and solder should fix this but I've got to find
a better route for that wire.
--
DougW
Thread
Thread Starter
Forum
Replies
Last Post
raym
General Jeep and Tech Talk.
1
04-29-2010 06:12 AM
Lon Stowell
Jeep Mailing List
3
11-09-2007 05:17 PM
Erich
Jeep Mailing List
48
01-30-2006 07:12 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)