My 1997 GCL Orvis Edition w/ 62K miles abandoned me tonight.

Went to dinner and a movie and upon returning to the vehicle it would
not start. Prior to this the Jeep has shown NO signs of imminent
failure.

It spins over very easy. I found the ignition coil at the front of the
engine, removed the wire, jammed a screwdriver inside the boot and held
it near the tower while the better half spun the engine - no spark
observed.

Am I close to the right area or should I keep trouble shooting? There
seems to be a lot written on crankshaft position sensors on these
vehicles. Since I'm working on the street is this a simple task to
replace? Where is this item located on the engine?

I'll be back out there at 8am tomorrow to start feeding the parking
meter it's stalled at.

Boy, a BMW X5 is looking better all the time.

 

This is usually not a street fix, the sensor should be on top of the bell
housing rear of block, but you need to trouble shoot this, check the asd
relay first.
<jailallspammers-online@yahoo.com> wrote in message
news:1134712076.461600.322690@g43g2000cwa.googlegr oups.com...
> My 1997 GCL Orvis Edition w/ 62K miles abandoned me tonight.
>
> Went to dinner and a movie and upon returning to the vehicle it would
> not start. Prior to this the Jeep has shown NO signs of imminent
> failure.
>
> It spins over very easy. I found the ignition coil at the front of the
> engine, removed the wire, jammed a screwdriver inside the boot and held
> it near the tower while the better half spun the engine - no spark
> observed.
>
> Am I close to the right area or should I keep trouble shooting? There
> seems to be a lot written on crankshaft position sensors on these
> vehicles. Since I'm working on the street is this a simple task to
> replace? Where is this item located on the engine?
>
> I'll be back out there at 8am tomorrow to start feeding the parking
> meter it's stalled at.
>
> Boy, a BMW X5 is looking better all the time.
>
>



----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----

 

This is usually not a street fix, the sensor should be on top of the bell
housing rear of block, but you need to trouble shoot this, check the asd
relay first.
<jailallspammers-online@yahoo.com> wrote in message
news:1134712076.461600.322690@g43g2000cwa.googlegr oups.com...
> My 1997 GCL Orvis Edition w/ 62K miles abandoned me tonight.
>
> Went to dinner and a movie and upon returning to the vehicle it would
> not start. Prior to this the Jeep has shown NO signs of imminent
> failure.
>
> It spins over very easy. I found the ignition coil at the front of the
> engine, removed the wire, jammed a screwdriver inside the boot and held
> it near the tower while the better half spun the engine - no spark
> observed.
>
> Am I close to the right area or should I keep trouble shooting? There
> seems to be a lot written on crankshaft position sensors on these
> vehicles. Since I'm working on the street is this a simple task to
> replace? Where is this item located on the engine?
>
> I'll be back out there at 8am tomorrow to start feeding the parking
> meter it's stalled at.
>
> Boy, a BMW X5 is looking better all the time.
>
>



----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----

 

This is usually not a street fix, the sensor should be on top of the bell
housing rear of block, but you need to trouble shoot this, check the asd
relay first.
<jailallspammers-online@yahoo.com> wrote in message
news:1134712076.461600.322690@g43g2000cwa.googlegr oups.com...
> My 1997 GCL Orvis Edition w/ 62K miles abandoned me tonight.
>
> Went to dinner and a movie and upon returning to the vehicle it would
> not start. Prior to this the Jeep has shown NO signs of imminent
> failure.
>
> It spins over very easy. I found the ignition coil at the front of the
> engine, removed the wire, jammed a screwdriver inside the boot and held
> it near the tower while the better half spun the engine - no spark
> observed.
>
> Am I close to the right area or should I keep trouble shooting? There
> seems to be a lot written on crankshaft position sensors on these
> vehicles. Since I'm working on the street is this a simple task to
> replace? Where is this item located on the engine?
>
> I'll be back out there at 8am tomorrow to start feeding the parking
> meter it's stalled at.
>
> Boy, a BMW X5 is looking better all the time.
>
>



----== Posted via Newsfeeds.Com - Unlimited-Unrestricted-Secure Usenet News==----
http://www.newsfeeds.com The #1 Newsgroup Service in the World! 120,000+ Newsgroups
----= East and West-Coast Server Farms - Total Privacy via Encryption =----