How does anyone lube the front knuckle of the front driveshaft double cardan
joint? I can't get to it w/my grease gun w/anything. It's blocked by the plate
which holds the xfer case in. I'm thinking I might drill or cut a hole in that
plate just so I can get to the front knuckle.
-Bill (remove "botizer" to reply via email)

 

You may have to remove ther shaft to get at it. I have a High Angle
Driveline raer shaft that I must pull to get at the front ujoint. Hey, it's
all part of upgrading your rig!
"Wblane" <wblane@aol.combotizer> wrote in message
news:20040425175129.01933.00000279@mb-m05.aol.com...
> How does anyone lube the front knuckle of the front driveshaft double
cardan
> joint? I can't get to it w/my grease gun w/anything. It's blocked by the
plate
> which holds the xfer case in. I'm thinking I might drill or cut a hole in
that
> plate just so I can get to the front knuckle.
> -Bill (remove "botizer" to reply via email)

 

You may have to remove ther shaft to get at it. I have a High Angle
Driveline raer shaft that I must pull to get at the front ujoint. Hey, it's
all part of upgrading your rig!
"Wblane" <wblane@aol.combotizer> wrote in message
news:20040425175129.01933.00000279@mb-m05.aol.com...
> How does anyone lube the front knuckle of the front driveshaft double
cardan
> joint? I can't get to it w/my grease gun w/anything. It's blocked by the
plate
> which holds the xfer case in. I'm thinking I might drill or cut a hole in
that
> plate just so I can get to the front knuckle.
> -Bill (remove "botizer" to reply via email)

 

You may have to remove ther shaft to get at it. I have a High Angle
Driveline raer shaft that I must pull to get at the front ujoint. Hey, it's
all part of upgrading your rig!
"Wblane" <wblane@aol.combotizer> wrote in message
news:20040425175129.01933.00000279@mb-m05.aol.com...
> How does anyone lube the front knuckle of the front driveshaft double
cardan
> joint? I can't get to it w/my grease gun w/anything. It's blocked by the
plate
> which holds the xfer case in. I'm thinking I might drill or cut a hole in
that
> plate just so I can get to the front knuckle.
> -Bill (remove "botizer" to reply via email)

 

You may have to remove ther shaft to get at it. I have a High Angle
Driveline raer shaft that I must pull to get at the front ujoint. Hey, it's
all part of upgrading your rig!
"Wblane" <wblane@aol.combotizer> wrote in message
news:20040425175129.01933.00000279@mb-m05.aol.com...
> How does anyone lube the front knuckle of the front driveshaft double
cardan
> joint? I can't get to it w/my grease gun w/anything. It's blocked by the
plate
> which holds the xfer case in. I'm thinking I might drill or cut a hole in
that
> plate just so I can get to the front knuckle.
> -Bill (remove "botizer" to reply via email)