old question about front grill
#1
old question about front grill
I want to remove the front plastic jeep grill and put a screen in there ,i see the 6 plastic use once
screws but what about the bottom ,does it just pull away and what have people used to replace the remove once plastic screws.
I want to start this job and finish it so i would like to know other's experiences
thanks
screws but what about the bottom ,does it just pull away and what have people used to replace the remove once plastic screws.
I want to start this job and finish it so i would like to know other's experiences
thanks
#2
Re: old question about front grill
they aren't "use once" screws. at least they werent on mine. The middles of them pop up and then the rest of the screw can come out. Once you have those out the grill should just pull away from the body, there are a few clips holding it on so give it a good tug and you should be good. This thread on JK-foum and pictures and step by step instructions by a lot of people who have done the same thing you want to do. Check it out. http://www.jk-forum.com/showthread.p...ight=grill+mod. Oh and dont forget to disconnect the blinker lights!
#3
Re: old question about front grill
Like Jenna said. Plastic retainers on rad support are reusable. Just pull out grill at the bottom. Bottom is just metal clip inserts. Reusable as well. Unplug the marker lights
( I just turned the light assy's out) and pull it off...carefully. You don't want to scratch
anything. Good luck.
( I just turned the light assy's out) and pull it off...carefully. You don't want to scratch
anything. Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)