How do I wire HiTorque Starter in my CJ3A
#1
How do I wire HiTorque Starter in my CJ3A
The starters in my vintage of Jeeps are not the best.I had it rebuilt 3 years ago and it got smoked the other day so we purchaced from Kaiser/****** their HiTorque Starter.We just came back from a 500 mile road trip in it so it run out great and we need to depend on it.
Its a 132 F head with a 12 volt system.
The Starter is fitted into place.
I installed a solonoid on the Fire Wall.
A water proof Push Button Switch now is where the old mech.starter switch was.
Im going to use the orginal On/Off Switch .
Does anyone have any diagrams on this installation.Im a good mechanic but I like to have a design to follow.The starter is very expensive an I dont want to smoke it with a mistake.
Its a 132 F head with a 12 volt system.
The Starter is fitted into place.
I installed a solonoid on the Fire Wall.
A water proof Push Button Switch now is where the old mech.starter switch was.
Im going to use the orginal On/Off Switch .
Does anyone have any diagrams on this installation.Im a good mechanic but I like to have a design to follow.The starter is very expensive an I dont want to smoke it with a mistake.
#2
Re: How do I wire HiTorque Starter in my CJ3A
I contacted a friend in NS that has a CJ and sent him your question this is what I received back I hope it helps. Go to this website there is a diagram http://www.samarins.com/glossary/starter.html
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)