1987 jeep comanche
#1
1987 jeep comanche
hey guys im new but im only here to try to sell my jeep
i bought it and did alot of work to it before the trans grenaded on me
it is a 87 shortbox 2.5l 5 speed 2wd
when i bought it the floor was rotten and same with over the wheels on the bed so i replaced it all with sheet metal sealer on the floors, i put new padding and carpet in the truck aswell. the brakes all around are new and a brand new gastank is there too.
the truck would make a GREAT donor for a 4.0l swap or even a trail buggy the body and frame are SOLID
aparently it has a dana 35 with 4:10 gears.( i dont know for sure but someone said it did and i dont know how to check)
i am looking to get $800 or best offer
NOTE: the truck does not drive now because the transmission is TOAST but the motor runs
you can email me at smurph_13@hotmail.com
or reach my cellphone at (519) 990-3168
the truck is located in windsor ontario
this is what the truck looks like now
these are what the truck looked like when i did all the work to it
i bought it and did alot of work to it before the trans grenaded on me
it is a 87 shortbox 2.5l 5 speed 2wd
when i bought it the floor was rotten and same with over the wheels on the bed so i replaced it all with sheet metal sealer on the floors, i put new padding and carpet in the truck aswell. the brakes all around are new and a brand new gastank is there too.
the truck would make a GREAT donor for a 4.0l swap or even a trail buggy the body and frame are SOLID
aparently it has a dana 35 with 4:10 gears.( i dont know for sure but someone said it did and i dont know how to check)
i am looking to get $800 or best offer
NOTE: the truck does not drive now because the transmission is TOAST but the motor runs
you can email me at smurph_13@hotmail.com
or reach my cellphone at (519) 990-3168
the truck is located in windsor ontario
this is what the truck looks like now
these are what the truck looked like when i did all the work to it
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)