03 Rubicon,6 inch long arm lift and 35s on 15x10 alloys.what should wheels be torqued to?(found several loose lugs pulling wheels to look things over)What size is the hex check and drain plug on TC?Thanks in advance

 

Whenever you change a wheel you should re-check the lug-nuts after a few days, this applies to all vehicles, but particularly to jeeps as they seem to be very good at loosening themselves. Should be around 100 ft/lbs.
Don't recall what size the level plug is on the t/case, but it's big.

 

Thanks,Was at a tire shop today,there chart say 00-04 wrangle 85-110 ft.lbs.think i will go with the upper limit being alloys!

 

17mm hex on trans,10mm hex on TC