Re: Track Bar Help..again
 

I believe so,
Snow...

"Wildman" <mjswildman@excite.com> wrote in message
news:ZwL%a.39390$2x.3724@rwcrnsc52.ops.asp.att.net ...
> Are you working with the original track bar?
> "Snow" <snowbal@sympatico.ca> wrote in message
> news:3b00e6a9.0308162002.5924464@posting.google.co m...
> > Ok got a couple quick questions about my track bar.
> >
> > Started the removal process today (was planning on changing the track
> > bar, rear sway bar, t-stat and mechanical fan) I managed to get the
> > bolt to removw from the eye end with lots of curesing and a bit of
> > heat from the good old propane torch (ok also had some flames too,
> > caused by all the release-all I srayed onto it over the past week),
> > When it came time to pull the cotter pin and remove the ball joint end
> > I had major problems... after finally picking out the bits of cotter
> > pin, and soaking the joint with more realease-all, I tried removing
> > the nut... to my surprise the whole d*mn joint is turning. So I go
> > over and look at the joint end on the new track bar, nope DOESN'T
> > rotate freely. Go back over and try removing the nut again, and same
> > thing the whole joint is rotating in the track bar...Right now I am
> > planning on taking to a local garage next week (after I buy a new
> > heater diverter? valve, old one broke up while changing the t-stat...a
> > story for a different day)
> >
> > How the h*ll am I going to remove this nut?? Ideas and suggestions
> > wanted.
> >
> > Thanks
> > Snow 93 XJ,.
>
>