Re: P0303 cylinder #3 misfire
Carl wrote:
> agreed. > > "billy ray" wrote ... >> If a coil was bad then two cylinders >> (3 and 4) would be misfiring. It can also be the rail. I've seen where the rail has failed internally and that was causing the misfire. -- DougW |
Re: P0303 cylinder #3 misfire
Carl wrote:
> agreed. > > "billy ray" wrote ... >> If a coil was bad then two cylinders >> (3 and 4) would be misfiring. It can also be the rail. I've seen where the rail has failed internally and that was causing the misfire. -- DougW |
Re: P0303 cylinder #3 misfire
Carl wrote:
> agreed. > > "billy ray" wrote ... >> If a coil was bad then two cylinders >> (3 and 4) would be misfiring. It can also be the rail. I've seen where the rail has failed internally and that was causing the misfire. -- DougW |
Re: P0303 cylinder #3 misfire
Ok, but for one coil power two cylinders I would think there is one
input connection on the coil to rail and one connection going to each plug with a connection at each plug, no? Haven't seen the setup yet. Mike bllsht wrote: > > A bad connection would kill either 2 or all cylinders. > > On Sat, 06 Jan 2007 20:32:50 -0500, Mike Romain <romainm@sympatico.ca> > wrote: > > >Or it's electronic plug and socket are dirty..... > > > >Mike > > > >Jeff Strickland wrote: > >> > >> So, one of the coils is bad. > >> > >> "Carl" <carlsaiyed@hotmailREMOVE.com> wrote in message > >> news:bdqdnb4NANz57QHYnZ2dnUVZ_tOmnZ2d@comcast.com. .. > >> > Jeff, no plug wires or dist cap on an 00 and 01. Coil rail with three coil > >> > packs. > >> > > >> > Carl > >> > > >> > > >> > "Jeff Strickland" <crwlr@yahoo.com> wrote in message > >> > news:OfidnY5u3NmnmQHYnZ2dnUVZ_h6jnZ2d@ez2.net... > >> >> With a misfire, I'd be looking at the plug wires or coil. I'd check plug > >> >> wires if there was a distributor, or I'd look at the coil if there was a > >> >> separate coil for each cylinder, or a coil for every two cylinders. > >> >> > >> >> > >> >> > >> >> "01XJ" <adam.tsacoumangos@gmail.com> wrote in message > >> >> news:1167779855.090317.153570@v33g2000cwv.googlegr oups.com... > >> >>>I just started experiencing a rough idle on my 2001 Cherokee (78k > >> >>> miles). My engine light went on a little after that with the P0303 > >> >>> code. I just replaced the spark plugs, but that didn't help anything. > >> >>> I was > >> >>> thinking about changing the ignition coil or fuel injector. One other > >> >>> possibility I was > >> >>> thinking was checking the cylinder compression (maybe a gasket leak?). > >> >>> Anyone have any suggestions? > >> >>> > >> >> > >> > > >> > |
Re: P0303 cylinder #3 misfire
Ok, but for one coil power two cylinders I would think there is one
input connection on the coil to rail and one connection going to each plug with a connection at each plug, no? Haven't seen the setup yet. Mike bllsht wrote: > > A bad connection would kill either 2 or all cylinders. > > On Sat, 06 Jan 2007 20:32:50 -0500, Mike Romain <romainm@sympatico.ca> > wrote: > > >Or it's electronic plug and socket are dirty..... > > > >Mike > > > >Jeff Strickland wrote: > >> > >> So, one of the coils is bad. > >> > >> "Carl" <carlsaiyed@hotmailREMOVE.com> wrote in message > >> news:bdqdnb4NANz57QHYnZ2dnUVZ_tOmnZ2d@comcast.com. .. > >> > Jeff, no plug wires or dist cap on an 00 and 01. Coil rail with three coil > >> > packs. > >> > > >> > Carl > >> > > >> > > >> > "Jeff Strickland" <crwlr@yahoo.com> wrote in message > >> > news:OfidnY5u3NmnmQHYnZ2dnUVZ_h6jnZ2d@ez2.net... > >> >> With a misfire, I'd be looking at the plug wires or coil. I'd check plug > >> >> wires if there was a distributor, or I'd look at the coil if there was a > >> >> separate coil for each cylinder, or a coil for every two cylinders. > >> >> > >> >> > >> >> > >> >> "01XJ" <adam.tsacoumangos@gmail.com> wrote in message > >> >> news:1167779855.090317.153570@v33g2000cwv.googlegr oups.com... > >> >>>I just started experiencing a rough idle on my 2001 Cherokee (78k > >> >>> miles). My engine light went on a little after that with the P0303 > >> >>> code. I just replaced the spark plugs, but that didn't help anything. > >> >>> I was > >> >>> thinking about changing the ignition coil or fuel injector. One other > >> >>> possibility I was > >> >>> thinking was checking the cylinder compression (maybe a gasket leak?). > >> >>> Anyone have any suggestions? > >> >>> > >> >> > >> > > >> > |
Re: P0303 cylinder #3 misfire
Ok, but for one coil power two cylinders I would think there is one
input connection on the coil to rail and one connection going to each plug with a connection at each plug, no? Haven't seen the setup yet. Mike bllsht wrote: > > A bad connection would kill either 2 or all cylinders. > > On Sat, 06 Jan 2007 20:32:50 -0500, Mike Romain <romainm@sympatico.ca> > wrote: > > >Or it's electronic plug and socket are dirty..... > > > >Mike > > > >Jeff Strickland wrote: > >> > >> So, one of the coils is bad. > >> > >> "Carl" <carlsaiyed@hotmailREMOVE.com> wrote in message > >> news:bdqdnb4NANz57QHYnZ2dnUVZ_tOmnZ2d@comcast.com. .. > >> > Jeff, no plug wires or dist cap on an 00 and 01. Coil rail with three coil > >> > packs. > >> > > >> > Carl > >> > > >> > > >> > "Jeff Strickland" <crwlr@yahoo.com> wrote in message > >> > news:OfidnY5u3NmnmQHYnZ2dnUVZ_h6jnZ2d@ez2.net... > >> >> With a misfire, I'd be looking at the plug wires or coil. I'd check plug > >> >> wires if there was a distributor, or I'd look at the coil if there was a > >> >> separate coil for each cylinder, or a coil for every two cylinders. > >> >> > >> >> > >> >> > >> >> "01XJ" <adam.tsacoumangos@gmail.com> wrote in message > >> >> news:1167779855.090317.153570@v33g2000cwv.googlegr oups.com... > >> >>>I just started experiencing a rough idle on my 2001 Cherokee (78k > >> >>> miles). My engine light went on a little after that with the P0303 > >> >>> code. I just replaced the spark plugs, but that didn't help anything. > >> >>> I was > >> >>> thinking about changing the ignition coil or fuel injector. One other > >> >>> possibility I was > >> >>> thinking was checking the cylinder compression (maybe a gasket leak?). > >> >>> Anyone have any suggestions? > >> >>> > >> >> > >> > > >> > |
Re: P0303 cylinder #3 misfire
Mike Romain wrote:
> Ok, but for one coil power two cylinders I would think there is one > input connection on the coil to rail and one connection going to each > plug with a connection at each plug, no? IIRC, five wires. three ecu grounds, two ecu battery. Plus and one connection for each plug http://www.wjjeeps.com/engine/coil_rail_assembly_01.jpg http://www.motorage.com/motorage/dat...30/article.pdf -- DougW |
Re: P0303 cylinder #3 misfire
Mike Romain wrote:
> Ok, but for one coil power two cylinders I would think there is one > input connection on the coil to rail and one connection going to each > plug with a connection at each plug, no? IIRC, five wires. three ecu grounds, two ecu battery. Plus and one connection for each plug http://www.wjjeeps.com/engine/coil_rail_assembly_01.jpg http://www.motorage.com/motorage/dat...30/article.pdf -- DougW |
Re: P0303 cylinder #3 misfire
Mike Romain wrote:
> Ok, but for one coil power two cylinders I would think there is one > input connection on the coil to rail and one connection going to each > plug with a connection at each plug, no? IIRC, five wires. three ecu grounds, two ecu battery. Plus and one connection for each plug http://www.wjjeeps.com/engine/coil_rail_assembly_01.jpg http://www.motorage.com/motorage/dat...30/article.pdf -- DougW |
Re: P0303 cylinder #3 misfire
One connector, 4 wires. 12v in and 3 driver wires.
On Sun, 07 Jan 2007 12:05:11 -0500, Mike Romain <romainm@sympatico.ca> wrote: >Ok, but for one coil power two cylinders I would think there is one >input connection on the coil to rail and one connection going to each >plug with a connection at each plug, no? > >Haven't seen the setup yet. > >Mike > >bllsht wrote: >> >> A bad connection would kill either 2 or all cylinders. >> >> On Sat, 06 Jan 2007 20:32:50 -0500, Mike Romain <romainm@sympatico.ca> >> wrote: >> >> >Or it's electronic plug and socket are dirty..... >> > >> >Mike >> > >> >Jeff Strickland wrote: >> >> >> >> So, one of the coils is bad. >> >> >> >> "Carl" <carlsaiyed@hotmailREMOVE.com> wrote in message >> >> news:bdqdnb4NANz57QHYnZ2dnUVZ_tOmnZ2d@comcast.com. .. >> >> > Jeff, no plug wires or dist cap on an 00 and 01. Coil rail with three coil >> >> > packs. >> >> > >> >> > Carl >> >> > >> >> > >> >> > "Jeff Strickland" <crwlr@yahoo.com> wrote in message >> >> > news:OfidnY5u3NmnmQHYnZ2dnUVZ_h6jnZ2d@ez2.net... >> >> >> With a misfire, I'd be looking at the plug wires or coil. I'd check plug >> >> >> wires if there was a distributor, or I'd look at the coil if there was a >> >> >> separate coil for each cylinder, or a coil for every two cylinders. >> >> >> >> >> >> >> >> >> >> >> >> "01XJ" <adam.tsacoumangos@gmail.com> wrote in message >> >> >> news:1167779855.090317.153570@v33g2000cwv.googlegr oups.com... >> >> >>>I just started experiencing a rough idle on my 2001 Cherokee (78k >> >> >>> miles). My engine light went on a little after that with the P0303 >> >> >>> code. I just replaced the spark plugs, but that didn't help anything. >> >> >>> I was >> >> >>> thinking about changing the ignition coil or fuel injector. One other >> >> >>> possibility I was >> >> >>> thinking was checking the cylinder compression (maybe a gasket leak?). >> >> >>> Anyone have any suggestions? >> >> >>> >> >> >> >> >> > >> >> > |
All times are GMT -4. The time now is 06:24 PM. |
© 2024 MH Sub I, LLC dba Internet Brands