Three weeks ago I installed a ARB bullbar and mounted IPF 968's and a set of Bosch compact 100's on bumper. I switched headlights with an IPF kit . This weekend I added extra backup lights, 4" led Trucklights. Now I see better front and back . Doug

 

Nice upgrade!

 

looks nice, I like that front bumper, reminds of the mopar a bit

 

Did you use a plug and play harness or did you wire some relays in to get the most power for the lights?

 

Very nice. I am considering something similar. whenever I get my new jeep that is...

 

I installed a Painless 7 cicuit fuse box on passengers side kick panel and I run all accessories from it . That way I have left Jeep factory system intact so there is no warranty issues Doug

 

This guy?

http://www.quadratec.com/products/97015_07.htm

 

Yes that the one, I mounted a termal strip below it ( makes adding acessories down thr road easy ) and used factory ground that is behind the kick panel , When panel is on it hides all of it. To power relay on fuse panel I tap in to drivers side power outlet , that way 3 or 4 cicuits go off with key, I run back up camera and all lights that way. I used the cicuits that are fed from battery for a rear power outlet in cargo area and one under dash for GPS. I hope this answers your question. Doug

 

Nice bumper! I am looking for something similar that you can keep the original fog lights and fit a winch, I am looking at the new Smittybilt XRC M.O.D. with the full width end plates. http://www.smittybilt.com/product/index/147.htm

 

Another place to chk out where u can see the product lots of times right in his showroom is national4wd in Chateauguay (website has toll free line)