2011 Jeep Wranger Trailer Wireing
can anyone confirm if the 2011 Jeep Wrangler's have a wire harness from the factory that you can just clip into? I was told there is a factory harness at the rear some where. I briefly had a look but coudln't find anything.
thanks |
Re: 2011 Jeep Wranger Trailer Wireing
I think that might be only if you get the towing package... I got it so I have it?
|
Re: 2011 Jeep Wranger Trailer Wireing
2 Attachment(s)
Originally Posted by Jenna
(Post 556295)
I think that might be only if you get the towing package... I got it so I have it?
|
Re: 2011 Jeep Wranger Trailer Wireing
thanks. No I don't have the two package but somome said jeeps are mostly wired. what I mean is on my old vehicle I had to wired a power wire right from the battery to the back and tape into my rear tail lights on both sides. My understanding is jeeps have this pre wired and there is a connection somewhere underneth near the rear. I will have to crawl under there and have a peek.
thanks |
Re: 2011 Jeep Wranger Trailer Wireing
Not pre wired, but the trailer kit from the dealer uses plugs that go between the two haves of the taillight plugs. No cutting required.
|
Re: 2011 Jeep Wranger Trailer Wireing
Originally Posted by JTPhoto JK
(Post 556358)
Not pre wired, but the trailer kit from the dealer uses plugs that go between the two haves of the taillight plugs. No cutting required.
|
Re: 2011 Jeep Wranger Trailer Wireing
Put one in my son's 07 sahara last fall. The only extra wire to deal with is a ground to the frame at the rear. All other wires are there in the rear harness.
|
Re: 2011 Jeep Wranger Trailer Wireing
I tried to follow the wire to see if it had a connection closer to the rear of the Jeep but no luck.
I installed a harness on a past vehicle I owned and all I needed to do was piggy back the harness wires and ground it to the frame. |
Re: 2011 Jeep Wranger Trailer Wireing
Originally Posted by AHunter
(Post 556417)
I tried to follow the wire to see if it had a connection closer to the rear of the Jeep but no luck.
I installed a harness on a past vehicle I owned and all I needed to do was piggy back the harness wires and ground it to the frame. |
Re: 2011 Jeep Wranger Trailer Wireing
Ya, buy a wiring harness for about $55. Remove the drivers side tail light, disconnect the wiring connector for it. Add in the new harness and reassemble taillight. I chose to remove the stupid floating foam plugs below both taillights, seal the openings with tape and aluminum flashing and then shoot in that foam-in-a can stuff. Don't use too much, especially around the fuel filler pipe breather. I built my own hitch receiver for $12, (Found factory one & took measurements) only because they wanted $250 for it at the dealer. Use the same bolts to mount it as those that hold on the hook - might have bought one more. Oh! polish all metal parts before assembly, then let it rust so you can't rub it off. Assemble and paint with rust-mort so it goes black, then paint with your choice of colours.
|
All times are GMT -4. The time now is 06:58 AM. |
© 2024 MH Sub I, LLC dba Internet Brands