Jeeps Canada - Jeep Forums

Jeeps Canada - Jeep Forums (https://www.jeepscanada.com/)
-   Jeep Grand Cherokee Forum (https://www.jeepscanada.com/jeep-grand-cherokee-forum-23/)
-   -   Check engine light (https://www.jeepscanada.com/jeep-grand-cherokee-forum-23/check-engine-light-121951/)

cor-32 May 2, 2011 04:28 PM

Check engine light
 
Took a turn, up a slight incline, the jeep started chugging/vibrating, check engine light came on, stopped engine, re-started, seems fine but light is still on....
I don't have an OBD, or afford a mechanic

Any suggestions/ideas??

thanks

CrazyWJ242 May 2, 2011 05:35 PM

Re: Check engine light
 
is it a 99 Grand?

you can go into your jeep, and turn your key On - Off - On - Off - On and a codes will come up on the odometer... post the codes up here

cor-32 May 2, 2011 05:37 PM

Re: Check engine light
 
jsut bout to post that! code is
P 0320, No reference signal (crankshaft position sensor) detected during engine cranking.

but i have no idea what that is, can i drive away till the weekedn? is it a fuse or a part?

CrazyWJ242 May 2, 2011 05:55 PM

Re: Check engine light
 
see when i got my code, my engine (4.0L) would just turn over but never fire up... im wondering if its just a fluke you got the error message... and everything is ok...

if your feeling brave, clear the PCM by disconnecting the battery and doing the key on off bit... then reconnect the battery...
there could be a small chance the jeep might not fire up, so only do this if you have an alternate means of transportation, and some $60 for a stupid sensor!

that sensor is located on the back of the transmission housing, and is a supreme bitch to get at...
i took the easy route, disconnected the driveshafts, and lowered the transmission and transfercase... but you might be able to get it from up top, just be a PITA...

Mr White May 2, 2011 10:14 PM

Re: Check engine light
 
"CrazyWJ242" What this? clear the PCM by disconnecting the battery and doing the key on off bit.(once or more than once)??.. then reconnect the battery.Thats it to clear the pcm? . Good to know. I had engine light come on the other day was a code P0155 (M) number 2 bank sensor malfunction . I cleared it with the obd11 and it hasn't returned. That only makes it a little rough at first run then cleans itself once the system gets warmed up. Too many senors on these vehicles now. :(

cor-32 May 2, 2011 10:17 PM

Re: Check engine light
 
i did that! i was looking at the box beside the battery, and disconnected the battery for the shits and giggles - re-connected it and ran the on-off tester - all good!

bullet dodged!

thanks folks!

CrazyWJ242 May 3, 2011 11:48 AM

Re: Check engine light
 

Originally Posted by Mr White (Post 556669)
"CrazyWJ242" What this? clear the PCM by disconnecting the battery and doing the key on off bit.(once or more than once)??.. then reconnect the battery.Thats it to clear the pcm? . Good to know. I had engine light come on the other day was a code P0155 (M) number 2 bank sensor malfunction . I cleared it with the obd11 and it hasn't returned. That only makes it a little rough at first run then cleans itself once the system gets warmed up. Too many senors on these vehicles now. :(

you do the key on - off - on - off -on, or On 3 times, and it should clear all the codes in the PCM... with the battery connected it'll retrieve them on the odometer...

im not sure if the TJ's have this feature or not, most likely though. i know both of my ZJ's do not.

I have to agree 100%, way too many sensors on these vehicles...


All times are GMT -4. The time now is 10:48 AM.


© 2026 MH Sub I, LLC dba Internet Brands

Page generated in 0.28230 seconds with 4 queries