standard Not Shifting into gear
 

ok i just replaced the slave and clutch, bleed the clutch, which is stiffer then it was. i put foot on clutch tried to put in 1st gear and it will not go. when i installed everything , the tranny was in nuetral as i removed it. the T-case on the other hand is in 4low to be nuetral. thinking i have remove T-case and switch to neutral then install again. this 88 lerado is my daily driver so i need to get this done ASAP. PLEASE........ HELP!

thanks

Re: standard Not Shifting into gear
 

shifter boot in the way maybe. Any tranny trouble before. Hope it not tranny

Re: standard Not Shifting into gear
 

sounds like something is not meshing properly,I know it sucks,but you're gonna have to disassemble,check and reassemble..and yes make sure everything is in Neutral.
Also how was the clutch bearing and did you replace it?You should any time you do the clutch.

Re: standard Not Shifting into gear
 

Are you sure that you did not put the clutch disc in backwards. I've seen it more than once. Same symptoms as you have.