Heater problem
#1
Heater problem
I have Jeep Liberty 2003 with a 3.7 engine.
I don't have heat coming out of my heater, I change the thermostat last Saturday, top it off after and run it and bleed it seem to be a little better but not enough at -20 degree ..... the compressor for the ac is clicking on and off but it's been like that for a long time and it was ok.
I need some advise for the next step.
Thank you.
lukuss72
I don't have heat coming out of my heater, I change the thermostat last Saturday, top it off after and run it and bleed it seem to be a little better but not enough at -20 degree ..... the compressor for the ac is clicking on and off but it's been like that for a long time and it was ok.
I need some advise for the next step.
Thank you.
lukuss72
#2
Re: Heater problem
I don't know where the cannister is on the Liberty (might be in wheel well or under hood) find it and check the lines from it to make sure they are not cracked. I am guessing that its run by compression and if there is a leak (cracked line) it won't work correctly.
Also check the hoses to and from the rad to see if there warm or not could be blockage preventing
Also check the hoses to and from the rad to see if there warm or not could be blockage preventing
Last edited by Mr White; 01-31-2016 at 09:06 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Jamie Mello
Jeep Mailing List
0
07-08-2007 01:01 PM
WildWestAZ
Jeep Mailing List
12
11-28-2005 06:37 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)